Manually test whether the feeding position is suitable. If there are any problems such as jamming and material skipping, use the Allen wrench to loosen the feeder locking screw, turn the adjusting rod to adjust until it is in the best state, and then tighten the feeder locking screw. Only after that can start work. Test the tensile force, after debugging the above steps, take the scrap wire and test it, carry out the tensile force test, press the zero button of the tensile force test to reset to zero, clamp the terminal wire to be tested, and carry out the test, if the measured tensile force is not within the standard range , ask the mechanic to adjust it again until it reaches the standard value.
There are two main reasons for the deviation of the automatic wire stripping machine. One is the centering module, and the other is the clamping part. The centering module determines the exact orientation of the stripping. If there is a problem with the centering module and an eccentricity is formed, one side of the core may be damaged, and the other side may be peeled incompletely. In the clamping part, the formed deviation part is mainly on the clamping jaw. There are debris on the jaws, and the orientation of the jaws is not correct, which will cause the deviation of the stripping wire. In addition, the loosening of the screws that fix the clips will directly lead to the problem of the jaws, which will also occur.
