Vibration should be reduced when the wire cutting machine is in use. In the production and processing process of the automatic terminal machine, the use of the tool is very important. During the cutting process, the vibration of the tool is mainly manifested in the phenomenon of vibration when the length is long and the workpiece is thin. In the process of high-speed cutting, a lot of noise will be generated, which will also cause harm to the human body. Correct and reasonable use of this wire cutting machine equipment can greatly reduce noise and reduce vibration.
The vibration during the use of the wire cutting machine can be divided into three ways: high-frequency vibration, medium-frequency vibration, and low-frequency vibration. There are many ways to reduce vibration, such as using a sharp tool, and using a 90-degree tool angle for slender workpieces To cut, adjust the specific parameters of cutting, reasonably arrange the process path of the tool, etc.
Teach you how to find out the fault that occurs when using the wire cutting machine. If the air pressure of the compressed air is too low, then, we will increase the air pressure, adjust the air pressure to more than 0.4MPA, and then set the total number, if the price is not 0, we will press the ESC key to clear it several times. In this way, Basically you can solve some crash problems. Of course, if it has not been solved, we must consider further maintenance, such as disassembly, such as some problems at the motherboard level. These are more complicated and already belong to the knowledge that professional mechanical maintenance personnel should master.
