Troubleshooting and repair of automatic tin dip machine:
1. The motor is faulty, the motor 180W is replaced, pay attention to the motor voltage.
2. Please check the proximity switch if the tin dipping machine appears continuously.
3. The mold is stuck and cannot slide up and down. Use a wrench to roll the screw at the end of the main shaft, so that the main shaft drives the slider to slide up and down to drive the punch, and check whether the upper and lower rivet knives are bumped, and the upper knife is stuck with tin.
4. The mechanical action is dull, add butter 1-3 times a day to the slider and the oil hole of the mold. Mechanical working environment temperature -2° to 50°.
5. The fuse is blown, replace it with a new one.
6. Replacement of the knife mold of the tin dip machine: When replacing the knife mold, please put the machine in the manual state. It is operated by designated personnel. Before installing the knife, it is necessary to perform a technical comparison to see if the selected blade is matched. After the comparison is correct, the knife can be installed. After the knife is installed, it is necessary to use a hand test. First, turn off the power of the tin dipping machine and press the adjustment button. , Use a special wrench to shake the main driven wheel, so that the tin dipping machine can reach the stamping stroke. If the hand does not move, consider whether the pressure is too large or other problems, and check the debugging to OK.
7. The switch of the pedal dip tin machine is not good, replace it with a new one
