The main points of the automatic terminal machine knife die replacement:
Be careful when changing the die, please make the machine in the manual state.
a, crimp height:
Loosen the screw of the adjustment module, rotate the lifting head, clockwise downward, counterclockwise upward, adjust the lifting head to the proper position, and adjust after locking.
b. Mold part:
Full pressure height adjustment, there are 10 indicators from 0 to 9. The larger the number, the smaller the height gap, and the difference between each number is 0.1mm.
Fine-tune the PVC pressure height, pull out and rotate, there are 8 indicators from 1-8, the larger the number, the lower the PVC blade height, and the height difference of each indicator is 0.1mm.
Check whether the tool and the terminal match, after appropriate adjustment, should meet the following standards:
There is no deformation at the back end of the crimping;
There should be a bell mouth on the crimping side of the terminal, and there should be no undesirable phenomena such as flying wire and glue;
After crimping, the shrapnel remains in its original shape;
After crimping, the wire tension and rubber tension should meet the tension standard.
Installation and use of the die of the automatic terminal machine: Note: The 2000 type die can be crimped for horizontal feeding, and the direct feeding terminal must select the corresponding horizontal feeding or direct feeding die according to the layout of the terminals used.
