What are the advantages of the mechanical properties of the automatic terminal machine?
1. The structure is stable and the cost of use is low: due to the effective reduction of the large-span cooperation of various mechanisms in the traditional operation process, the running-in of mechanical transmission is reduced, and the unstable factors are greatly reduced. The simplification of the structure greatly reduces the follow-up maintenance cost.
2. Advanced structural design: Breaking the traditional meaning of automatic and mobile operation process layout, the cutting, peeling, end-stripping and twisting are highly integrated in a straight line.
3. The advanced production efficiency of the fully automatic terminal machine: because the various operating mechanisms are integrated in a straight line, the production time of a single electronic wire is reduced, and the production capacity is surprisingly several times higher than that of the traditional model.
Analysis of the details and precautions of the use of the automatic terminal machine
1. The productivity of the automatic terminal machine is the commonly used current of 220 volts and some compressed gas, so the corresponding power switch and air pressure switch must be turned on before starting the production.
2. The power cord of the automatic terminal machine should be connected to a ground wire, otherwise static electricity will hurt the staff;
3. The automatic terminal machine should be lubricated with lubricating oil before starting. Then check and tighten the loose screws and corresponding equipment, and then release the moisture in the air path;
4. The pressure of the automatic terminal machine can be adjusted: if the pressure of the terminal machine is too large, the terminal of the wire may be damaged. If the pressure is too small, the terminal will slip off the wire conductor. Adjustment method: Loosen the three screws in front of the slider, slide the adjustment screw on the slider head clockwise, you can increase the pressure, and then you can lock the three screws in front of the slider, on the contrary, the pressure will be reduced
