In the daily production process, the inspection and cleaning work before the operation of the terminal machine is very important. If one part fails, it will affect the normal operation of other parts, making the failure more serious. If an abnormality is found, it needs to be repaired in time. In this way, normal production or other unnecessary losses can be reduced due to the failure of machinery and equipment. Not all faults need to be dealt with by engineers. It is extremely important to master some tips for troubleshooting. First of all, you can judge the causes of terminal machine faults from the following aspects:
A. The clutch of the terminal machine is not positioned, and the motor cannot be started if it is stuck. Possible improper operation and bad mold.
1. To exclude the manual operation of the slider, push the open handle in, turn the main shaft, and put it in with the open wrench.
B. The motor and pulley are running normally and the machine cannot work.
1. The electromechanical magnet of the terminal is bad, replace it with a new one.
2. The electrical circuit board of the terminal machine is faulty, replace it with a new one.
3. The foot switch of the terminal machine is bad, replace it with a new one.
C. The mold is stuck and cannot slide up and down
1. Rotate the pulley once by hand, so that the main shaft drives the slide to drive the punch, and check whether the upper and lower riveting is bruised, and the terminal machine is stuck on the upper knife.
