Computer wire cutting machine is a widely used wire end processing equipment. It is essential for wire rod factories. The performance of computer wire cutting is directly related to production efficiency. It is especially important to understand the machine and how to solve the problems encountered in the production process. The following 3 points are the common problems and solutions of computer wire cutting machine:
1. Why does the wire cutting machine easily cut off the copper wire when cutting the wire? The main reason is that the knife value is too small. Solution: You need to increase the knife value, and the adjustment range of the knife value should be determined according to your existing wire, and it can be corrected.
2. There is an alarm sound when the wire cutting machine starts up? Please check whether the parameters are set correctly. Please note that a prompt will appear in the upper left corner of the LCD frequency. Please check the numbers appearing on the prompt and make corrections according to the manual.
3. Why can't the skin be peeled off? The main reason is that the knife value is too large. Need to adjust the small knife value, the roller pressure is too small, you need to increase the pressure; the gap between the upper and lower rollers is larger than the wire, and needs to be adjusted to be smaller than the wire center; if the blade is damaged or worn, it needs to be replaced with a new tool.
