When using the automatic terminal machine, first turn on the power switch, and the indicator light will be on. If it does not light up, there may be a fault problem, and a detailed inspection is required at this time. After turning on the power, don't rush to start work. The first thing you need is to pay attention to whether there is any abnormal noise inside the machine. If there is abnormal vibration or noise, you should stop it immediately and carry out maintenance. After we set the parameters, press the machine to start the sword. The internal system will give the servo a working signal, and this signal will be transmitted to the working drive motor through a series of components, and then realize the start and stop of the work. It can be said that the entire workflow is done automatically, so the work efficiency is higher.
1. If there is "sweat" on the wall, it is recommended to buy a dehumidifier for dehumidification. Use an industrial dehumidifier for better results.
2. In long-term humid areas, charcoal can be placed in the room or bamboo charcoal can be placed under the indoor floor, which has a good effect on the balance of room humidity, dust prevention and air purification. Generally, it is better to cover the floor of the workshop with cardboard boxes.
3. It is a good dehumidification method to put some quicklime mixed with some sand in a relatively humid dead corner.
