Common faults and solutions of tin dip machine:
One: The cutting length of the electronic wire of the automatic tinning machine is different
1. The wire drive wheel is too tight or too loose. If this phenomenon causes problems, we only need to use the rolling line to rotate to adjust the gap between the two wheels, so that the cable is not flattened and too loose to fall off. This mechanical failure can be completely solved;
2. If the straightening device is too tight or too loose, if it is due to this problem, our correct treatment should be based on the basic principle of being able to play the role of the straightening device and successfully complete the delivery, so as to completely solve it;
3. Cutting edge damage or edge, in this case, we just need to remove and replace with a new one.
Two: Machines and equipment cannot run or stop in rotation
First check whether there is current input, then check whether the total number of settings is reached, whether the wire or an operating part is stuck, and then check whether the automatic tin dipping machine has a signal connection or power connection, so that the tin dipping machine does not press.
